![]() Open the app and follow its instructions to connect the BMV-712 to your phone. It’s easier in the app, so that’s what I did. To do so, you can either use the BMV-712’s screen or the free VictronConnect app. What is its amp hour capacity? Its state of charge? Its charged voltage? Now you need to tell the BMV-712 about your battery. Plug the screen in to the shunt and it should turn on.Īt this point, your monitor is installed and it needs to be set up. Then stick the red power cord into the shunt’s first battery port and connect the ring terminal to your battery bank’s positive terminal. Once everything is mounted, you connect the shunt terminal labeled “Battery Only” to your battery bank’s negative terminal. Lastly, if you can’t or don’t want to drill a hole in your wall, you can buy Victron’s wall-mounted enclosure, mount the enclosure to the wall, and then put the screen inside that. Second, you can use the included mounting plate and screws to mount the screen that way. The drawback to this method is that it requires you to get your hand behind the wall, which isn’t always possible. The screen can be mounted in 3 ways, which gives flexibility compared to other battery monitors whose screens can only be mounted 1 way.įirst, you can use a 2 1/8″ hole saw or slightly bigger to drill a hole in the wall and then screw the included mounting sleeve on the back to hold it in place. Or you can use a drill and 2 screws to mount it to a wall. To mount the shunt, you can tape it to a surface, such as the top of a battery, using double-sided mounting tape. It’ll make installation and setup a lot easier. Before installing, I recommend disconnecting everything from your battery and charging it to 100%. The Victron BMV-712 has 2 parts that require mounting: the shunt and the screen. Victron BMV-712 Smart Review Installation ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |